leblanc
asked on
ASA 5500 series enable password
I have enable password configured but when I ssh to it, at the password prompt, I can just press enter and access the ASA without the password. How do I fix this? Thanks
ASKER
I did not configure the ASA. But I see from the config that it has everything, except "crypto key generate rsa modulus 1024".
ASKER CERTIFIED SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.
ASKER
The ASA has an old 8.2 code. So I am just wondering if there is a bug or something. Thanks
Might be. You can upgrade the ASA image and try that too.
have you re-applied the command and tested ?
have you re-applied the command and tested ?
username exampleuser1 password examplepassword1
enable password password
crypto key generate rsa modulus 1024
aaa authentication ssh console LOCAL
ssh 192.168.1.2 255.255.255.255 inside