I have been asked to setup a Cisco 2504 Wireless controller with a Cisco Aironet 700 Series (AIR-CAP702I-A_K9) access point. When I got to the site I was handed a postcard size set of instructions. I connected to the 2504 using a browser and following the few instructions I went through the setup wizard. After the reboot I have never been able to connect to the 2504 using a browser. I can connect and change settings using the console cable and Putty. I need some simple instructions (if they exist) to get this set up and running. I need some basic instruction. I would rather not say "I was unable to.." I would rather say "With help from Experts Exchange..."