AXISHK
asked on
Configure multi-IP subnet on Sonicwall
https://support.software.dell.com/zh-cn/kb/sw5857
Base on the reference link above, Pro4060 (on RHS) will connect to a main switch where several VLAN is routed internally.
How should I define the address objects in Site A Sonicwall in Step 1 ? Can I just define the subnet for sonicwall and core switch and configure a static route in Pro4060 to route to other subnets from Site A to Site B.
Any example on this scenario ?
Tks
Base on the reference link above, Pro4060 (on RHS) will connect to a main switch where several VLAN is routed internally.
How should I define the address objects in Site A Sonicwall in Step 1 ? Can I just define the subnet for sonicwall and core switch and configure a static route in Pro4060 to route to other subnets from Site A to Site B.
Any example on this scenario ?
Tks
Typically you would define the entire subnet as shown in the example. Once you have the STS VPN setup you would then define what can be accessed on each end, and would detail the VLAN there.
ASKER
the subnets does not include in continuous range, I need to includes each of them?
ASKER CERTIFIED SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.
ASKER
Tks