asked on
SBS 2011 - DHCP Stopes servicing clients
Hello,
We have SBS 2011, which started to log event ID 1041 - The DHCP service is not servicing any DHCPv4 clients because none of the active network interfaces have statically configured IPv4 addresses, or there are no active interfaces.
And sometimes some of the computers cannot get IP addresses.
I checked the DHCP server bindings according to Microsoft, but everything seems fine there. Could you please advise, what else I should look for ?
Thank you,
We have SBS 2011, which started to log event ID 1041 - The DHCP service is not servicing any DHCPv4 clients because none of the active network interfaces have statically configured IPv4 addresses, or there are no active interfaces.
And sometimes some of the computers cannot get IP addresses.
I checked the DHCP server bindings according to Microsoft, but everything seems fine there. Could you please advise, what else I should look for ?
Thank you,
DHCPSBSMicrosoft Legacy OS
Last Comment
goliveuk
ASKER CERTIFIED SOLUTION
THIS SOLUTION ONLY AVAILABLE TO MEMBERS.
View this solution by signing up for a free trial.
Members can start a 7-Day free trial and enjoy unlimited access to the platform.
ASKER
Muhammad Burhan - the server is on static IP address. It is running fine for two years.
ASKER
Larry Struckmeyer MVP - I will run the wizard and post the results.
disable your adapter and then re enable it, lets see what happens in logs regarding DHCP.
Hello,
Check the power Management settings on your network adaptor and make sure that the option for 'Allow the computer to turn off this device to save power' is unchecked.
Check the power Management settings on your network adaptor and make sure that the option for 'Allow the computer to turn off this device to save power' is unchecked.
Have you buy chance disabled IPv6 on the server?
ASKER
Just ran a Fix my network wizard, it showed issue with DNS server, which is now fixed and I am monitoring the system for a couple days.
Because the DHCP server is responsible for servicing IPs so you have to configure its IP settings manually.