nh6we
asked on
Manual Priming of a Cisco 3702 access point
I am trying to prime a Cisco 3702 for autonomous mode. Following the Cisco guide it should be as easy as opening a browser and entering the IP address. The problem is I can ping the access point but from the browser I get a connection refused. Am I missing something? As anyone run across this before?
Thanks for the help
Thanks for the help
What version of autonomous code did you install on the AP? What was the file name?
ASKER
I just pulled the access point out of the box. I haven't loaded anything. I am stuck on the "Preparing for Manual Priming" section.
OK so you'll be connecting it to a controller, not using it in autonomous mode?
ASKER
no, I will not be using a controller. I am trying to set it up in autonomous mode. This AP will be used as a wireless survey access point
OK so which manual priming bit are you following??
ASKER
On page 10 of the "Cisco Aironet Universal AP Priming and Cisco AirProvision User Guide". The section on "Preparing an Autonomous AP for Manual Priming.
I never get past step 2
I never get past step 2
Ah ok. So are you just looking to use the smartphone app to configure the AP?
When you've found the IP of the AP in DHCP you should open the AP in a browser...
http://<AP_IP>
(You may be able to use HTTPS too)
That should prompt you to enter a user/pass. Just enter Cisco as the password (no username).
When you've found the IP of the AP in DHCP you should open the AP in a browser...
http://<AP_IP>
(You may be able to use HTTPS too)
That should prompt you to enter a user/pass. Just enter Cisco as the password (no username).
ASKER
no actually thats my problem. I can ping the access point but I am unable to http to it. When I try nothing happens. I get an error saying connection refused.
Can you telnet or SSH to it?
Do you have a proxy configured in your browser?
Do you have a proxy configured in your browser?
ASKER
Hey - thanks for the help, but at this point I think I should open a TAC.
Thanks again
Thanks again
ASKER CERTIFIED SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.