patron
asked on
Host Profile issue on Esxi 5.5 U3a
Recently applied host profile on my new host added in cluster.but always getting few errors while doing compliance check..
Option ScratchConfig.ConfiguredSc ratchLocat ion doesn't match the specified criteria status is non-compliant
i can see config is okay,host rebooted but no luck ?
and on another host i am getting error..
Failed to execute command to configure or query coredump partition. -status is unknown
please advise how this can be resolved, as i have single host profile in my cluster and it is compliant for rest 6 host but not on 2 recently added in cluster .
Option ScratchConfig.ConfiguredSc
i can see config is okay,host rebooted but no luck ?
and on another host i am getting error..
Failed to execute command to configure or query coredump partition. -status is unknown
please advise how this can be resolved, as i have single host profile in my cluster and it is compliant for rest 6 host but not on 2 recently added in cluster .
ASKER CERTIFIED SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.
hi there:
esxcli system syslog config get (can you give us the output)
regards
esxcli system syslog config get (can you give us the output)
regards
SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.
ASKER
tried everything, yet getting this issue again n again,..?
what i am doing is..
Have 1 host profile already attached to cluster, recently added 2 new esxi 5.5 host in cluster,applied profile.
but when doing compliance check it is showing unknown or non compliant due to error...
1. "Host requires reboot before previously applied configuration changes will take effect"
Tried with mutiple reboot,but always asking for this message with status non compliant ?
And below on other host..
2. Option ScratchConfig.ConfiguredSc ratchLocat ion doesn't match the specified criteria status is non-compliant
3. Failed to execute command to configure or query coredump partition. -status is unknown
what i am doing is..
Have 1 host profile already attached to cluster, recently added 2 new esxi 5.5 host in cluster,applied profile.
but when doing compliance check it is showing unknown or non compliant due to error...
1. "Host requires reboot before previously applied configuration changes will take effect"
Tried with mutiple reboot,but always asking for this message with status non compliant ?
And below on other host..
2. Option ScratchConfig.ConfiguredSc
3. Failed to execute command to configure or query coredump partition. -status is unknown
ASKER
Thanks
ASKER
configured everything using that profile but when doing compliance check getting non complaint .