Member_2_6346575
asked on
Meraki Cisco MR 18
Dear All
I hope your all doing well, I need some advice one what the best practice would be for the below:
I have one site that will require 2x MR18's one on either side of the floor, these will provide the wireless but I want to know what the best way would to configure these. I was considering to naming the SSID's the same , channels the same. So that when users move around they connect to the best connection.
I would like to know what you think so I can make an informed choice,.
I hope your all doing well, I need some advice one what the best practice would be for the below:
I have one site that will require 2x MR18's one on either side of the floor, these will provide the wireless but I want to know what the best way would to configure these. I was considering to naming the SSID's the same , channels the same. So that when users move around they connect to the best connection.
I would like to know what you think so I can make an informed choice,.
ASKER CERTIFIED SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.
Set up and account on the Meraki Website
Then add these Access points by serial number (it's on the back) or by order number.
You then setup the SSID in the portal and within 10 minutes your Access points will configure themselves accordingly. (its usually quicker, but Ive noticed take a little longer recently).
Pete