Link to home
Start Free TrialLog in
Avatar of deewave
deewaveFlag for Canada

asked on

Sonicwall - Multiple subnets on same interface

Hi

On NSA240, trying to figure out how to have multiple subnets on the same interface (LAN X0)

I've created a Virtual Interface with X0 as 'parent' interface, and IP address 192.168.0.1

On the switch connected to X0, I have some computers on 10.40.64.0 / 24 network and some on 192.168.0.0 / 24 network.

192.168.0.x computers can communicate between each other, they can also ping their gateway 192.168.0.1, but they can't go on the WAN.

Anyone know how to do this? Is there a way to do this without the use of vLAN? I've found this kb, but the link inside is dead https://support.software.dell.com/kb/sw7711

Thanks in advance
Avatar of Carl Dula
Carl Dula
Flag of United States of America image

The link you listed above works for me.
Avatar of deewave

ASKER

Yes I know, the link I mentioned above works fine. But it brings a page where it says

To download / view the technote please Click Here.

"Click Here" brings a Page Not Found
ASKER CERTIFIED SOLUTION
Avatar of Shane McKeown
Shane McKeown
Flag of Ireland image

Link to home
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.
Start Free Trial
Avatar of deewave

ASKER

Thanks smckeown777, found it at the same time!

Works perfectly, except we need to make a change in the first section:

Under Network Menu Click Address Objects.
Name: My Secondary Subnet (or any friendly name)
Zone Assignment: LAN
Type: Network
Network: 192.168.10.1 change it to 192.168.10.0
Netmask: 255.255.255.0 (This is for a /24 change as needed)
Click OK