I have no idea what I am doing wrong. In the image attached, I have 3 areas. Area 0 backbone which is the SWITCH in the middle. Area 30 which is connected to R6 (ABR) to R17 which is only in area 30. Then I have area 10 of which 48 is an ABR and R13 IS only in area 10.
What I did was I configured R6 is a "totally stubby area" since it's an ABR and R17 is a "STUB" Then I go to R13 which is ONLY in area 10 and do "show ip route" its still showing me routes of R17 and R18 in far top right. why is it?
So I started playing with this. I made R6 and R17 "totally stubby" by issuing "area 30 stub no-summery" on both routers. I go back to R13 and I still see all the routes of R17 and R18.
Then, I even changed R18 to "totally stubby" (which I know is not right) and still I still see all the routes of R17 and R18.
What am I doing wrong?