Open Port on Juniper SSG 140

I need to allow all incoming traffic on a specific port to any internal IP.  I need to allow any outgoing traffic on that same port to two different public web addresses.  How do I configure this on a Juniper SSG140?
Who is Participating?
I wear a lot of hats...

"The solutions and answers provided on Experts Exchange have been extremely helpful to me over the last few years. I wear a lot of hats - Developer, Database Administrator, Help Desk, etc., so I know a lot of things but not a lot about one thing. Experts Exchange gives me answers from people who do know a lot about one thing, in a easy to use platform." -Todd S.

RafaelArchitect - Network Engineer - InstructorCommented:
Are you going through the GUI or CLI ?

PDISAuthor Commented:
I would prefer the GUI but I can go through the CLI
Sanga CollinsSystems AdminCommented:
You can use this guide to configure a mapped IP (MIP) this should accomplish what you need.

Let us know if you need clarification on any steps in the KB

Experts Exchange Solution brought to you by

Your issues matter to us.

Facing a tech roadblock? Get the help and guidance you need from experienced professionals who care. Ask your question anytime, anywhere, with no hassle.

Start your 7-day free trial
It's more than this solution.Get answers and train to solve all your tech problems - anytime, anywhere.Try it for free Edge Out The Competitionfor your dream job with proven skills and certifications.Get started today Stand Outas the employee with proven skills.Start learning today for free Move Your Career Forwardwith certification training in the latest technologies.Start your trial today
Hardware Firewalls

From novice to tech pro — start learning today.