xerox phaser 4500 printer - printing in economy mode?
My OS is win 10 pro 64 bit and I have downloaded the latest drivers for win 10 or this printer. After initial hiccups of getting it to print, I finally managed got it to print. But now it prints, as though in economy mode, faint laser copies. How do I dive into the setings to see if this set to economy mode or something else got triggered. Thank u.
SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.
SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.
SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.
SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.
ASKER CERTIFIED SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.
in response to Matthew Minor, I have visited to the page as u advised. But no where in any of the tabs, like Security, Device Settings, Configuration, Options, General, Sharing, Ports, Advanced, Color Management, do I see any setting for economy mode. Unless I have installed the wrong driver for the printer. The Property Identification says it is a Phaser 4500B, and the label above LCD panel on the printer says ; phaser 4500. So I am lost. Thank u.
SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.
SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.
in response to Matthew, could u please advise how I get to CentreWare. Thank u.
SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.
SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.
My apologies Matthew, how do I find my printer's IP address, since it is not connected to the network, only by a USB cable to the desktop. Thank u.
SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.
In response, to Matthew, it is old toner. I really did shake it up, but it still prints the same. Let this present toner run out, and when I replace it let me see if the printing changes. Thank u very much.
Toner is black and does not normally fade. See what happens, but it looks like it may be a printer issue.
thank u everyone for your suggestions and advise. Thank u
@jegajothy - You are always welcome and I was happy to help.
ASKER
Regards.