Configure an HP Layer 3 switch with an  HP layer 2 switch for VLANS and Static Routing

Warmad
Warmad used Ask the Experts™
on
I have an HP 1920 Layer 3 and I have two HP Procurve 2530 PoE Switches. I want to have 6 Vlans. How do I create the static routes so that all Vlans have access to all servers, printers and the internet?
Comment
Watch Question

Do more with

Expert Office
EXPERT OFFICE® is a registered trademark of EXPERTS EXCHANGE®
Instructor
Top Expert 2015
Commented:
On the switch is doing the inter-VLAN routing, use the command "ip route x.x.x.x y.y.y.y z.z.z.z" where x is the network, y is the mask and z is the next hop address.
Aaron TomoskyDirector of Solutions Consulting
Commented:
I don't know the exact commands but here is the high level:
1. Add the vlan to the switch
2. Add the interface to the vlan (this is what things use as their gateway for the subnet)
3. Configure ports for access/trunk, and allowed vlans
4. Setup setup qos or acl or anything else you may need.

As to routes, you add those in your firewall or other routing devices as they need to know about the subnets you made in the vlans
TimotiStDatacenter Technician
Top Expert 2012

Commented:
Didn't see a 1920 yet, is it GUI-only, like the 1910?
Aaron TomoskyDirector of Solutions Consulting

Commented:
cleanup

Do more with

Expert Office
Submit tech questions to Ask the Experts™ at any time to receive solutions, advice, and new ideas from leading industry professionals.

Start 7-Day Free Trial