manuverhaegen
asked on
C7000 enclosue, Virtual connect 2 uplinks Active Active not working
Hi,
We have a C7000 enclosure with 2 Virtual connect modules.
Each virtual connect module is connected with 1 SFP 10G cable to the network switch (cisco)
We have make a LACP trunc on this 2 uplink cables on the cisco switch
1 link is Active but the second is Pasive, how can we make this active/active?
network.png
We have a C7000 enclosure with 2 Virtual connect modules.
Each virtual connect module is connected with 1 SFP 10G cable to the network switch (cisco)
We have make a LACP trunc on this 2 uplink cables on the cisco switch
1 link is Active but the second is Pasive, how can we make this active/active?
network.png
ASKER CERTIFIED SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.
ASKER
In your setup you have automatic a active pasive configuration
I attach the network picture.
network.png
I attach the network picture.
network.png
So how did you go with the steps to resolve your issue ?