netcmh
asked on
Cisco 2960 PACL
I've enabled private VLAN edges on our switches. Now, a user needs RDP access to his PC from another workstation. He is a member of the Remote Admin group on his PC. How do I configure the port to allow the RDP access, without removing the switchport protected config?
Thank you.
Thank you.
ASKER
Sounds like an option. Knowing the source & destination helps, but what if they're on 2 different floors on 2 different switches?
I don't think you can span private vlan communities between switches, unfortunately. I might be wrong on this one, though.
VTPV3 supports the transfer of private vlans between switches. So the same pvlan community would be available anywhere in the VTPV3 domain.
So just add it to the same community
harbor235 ;}
So just add it to the same community
harbor235 ;}
There we are, I stand corrected! :)
ASKER
I would like to see an example if you could rummage something up. Preferably not from Cisco.com. I have selective illiteracy when it comes to that site :)
ASKER CERTIFIED SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.
SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.
ASKER
Thank you.
Are you sure you actually need private VLANs? They sound great for protection and all, but kill a fair amount of features, like DHCP safeguards, Netbios discovery and pretty much anything, where hosts on the same subnet have a legit need to communicate with each other...
Tamas