WellingtonIS
asked on
Citrix Xapp 7.8
I've built a Citrix Server version 7.8 I do not have a netscaler. Instead I'm trying to use NAT to get to the server. I've done this sucessfully however, it will not launch the application. It starts to and then Citrix receiver fails with the following error:
Unable to launch your application... Cannot connect to the Citrix XenApp Server. There is no Citrix XenApp server configured on the specified address.
How do I know what address it's looking for? It's a nat on my fire wall from an outside address to an inside address Is there anyway around this besides purchasing a Netscaler Gateway??
Unable to launch your application... Cannot connect to the Citrix XenApp Server. There is no Citrix XenApp server configured on the specified address.
How do I know what address it's looking for? It's a nat on my fire wall from an outside address to an inside address Is there anyway around this besides purchasing a Netscaler Gateway??
ASKER CERTIFIED SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.
As Carl says, NetScaler is required. There is the free VPX version but it only supports a small amount of connections (about 5, IIRC). If you're just testing, this may suffice.
ASKER
Thanks. I guess I have to go back to 7.6