Configure Call Manager Express 4.0 to use external Gateway(s)

swensonj
swensonj used Ask the Experts™
on
Were dealing with a Cisco call manager express older version 4.0 running on a 2801 router.  Presently the CME is set up to also be a gateway using a T-1 CAS line to the teleco.  I'd like assistance on turning off the gateway functions of the CME and then configuring it to use two external gateways located on other networks but in the same Teleco area, one for local calls and one for LD calls.  Can anyone assist on this?
Comment
Watch Question

Do more with

Expert Office
EXPERT OFFICE® is a registered trademark of EXPERTS EXCHANGE®
Well, first disable all the dialpeers that would route calls through the T1 ports. Then configure new dialpeers to match Telco numbers such as

dial-pattern 911
dial-pattern  9..........

and point to an H.323 IP address which is the external gateway address. It all boils down to these 2 steps, but there are many many steps within each one that you would need to go through.

Author

Commented:
I think I can figure this out from here

Author

Commented:
I've requested that this question be deleted for the following reason:

Can't figure out how to accept the response and close the question

Author

Commented:
Every time I select the best solution it goes nowhere

Do more with

Expert Office
Submit tech questions to Ask the Experts™ at any time to receive solutions, advice, and new ideas from leading industry professionals.

Start 7-Day Free Trial