nomi4u666
asked on
BOVPN Created but cant Ping the whole local network from remote host
i am using Watchguad Xtm 330 firewall. I create a BOVPN on my end. My vpn tunnel is
local 192.168.1.0/24 and
remote 192.168.60.8/29.
phase 1 setting
Mode: Aggressive
Nat traversal : 30s
3DES-SHA1 DH2
Phase 2 Setting
3DES -SHA1
SA life 8 Hours
i have same setting on remote Router which is TL-R600VPN . My VPN is up but when i tried to ping from Remote host (192.168.60.10 ) to my network i can ping some network address not all network address. but when i ping any local network address from remote host so i can see the request in Watchguard traffic moinitor ( which goes to by default policy BOVPN allow-In). So any suggestions about this
local 192.168.1.0/24 and
remote 192.168.60.8/29.
phase 1 setting
Mode: Aggressive
Nat traversal : 30s
3DES-SHA1 DH2
Phase 2 Setting
3DES -SHA1
SA life 8 Hours
i have same setting on remote Router which is TL-R600VPN . My VPN is up but when i tried to ping from Remote host (192.168.60.10 ) to my network i can ping some network address not all network address. but when i ping any local network address from remote host so i can see the request in Watchguard traffic moinitor ( which goes to by default policy BOVPN allow-In). So any suggestions about this
Did you exclude VPN traffic from natting and do you have routes that are needed to forward traffic properly on both locations? Even if one side have all needed routes, it is essential that other side also have proper routes so traffic can be forwarded properly,otherwise... ping (and any other traffic) will fail.
ASKER CERTIFIED SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.
ASKER
i put the question and found the solution by myself