PeraHoman
asked on
Fractional T1 to Full T1 Frame Relay
Anyone have experience upgrading a fractional T1 to Full T1? What did you need to do on your side of the circuit? Change the timeslots to use all 1-24? Anything about CIR BC BE?
ASKER
They use frame relay at the site. I was thinking all we had to do was open the timeslots and change the bandwidth on interface and sub interface for routing calculations, but then i saw a class-map with cir, bc, be, and wasnt too sure about the classmap
ASKER CERTIFIED SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.
I've done this many times on Cisco routers with the old DSU WICs.
Basically, going to a full T1 greatly simplifies everything. Double-check with your telco what settings to use, but it is probably as simple as:
!
interface Serial0/0
ip address w.x.y.z 255.255.255.q
encapsulation ppp
!