Thomas_1991
asked on
SCCM Boundary Group for CAS dont work
In my test lab i try to add a boundary group to the boundary which i want to use for the CAS.
Im not able to add the CAS server to that group. Is that because the groups are used for Client Push installation?
Is there a need to configure boundarys for the CAS?
Im not able to add the CAS server to that group. Is that because the groups are used for Client Push installation?
Is there a need to configure boundarys for the CAS?
ASKER CERTIFIED SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.
SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.
ASKER
Regarding the CAS: When i add Boundarys at my primary sites, i also see them when i check the boundarys on the CAS. is that also normal or just a bad configuration in my lab?
Does the CAS or primary site need a IP Address from the configured boundary or is just network connection needed with the configured boundarys?