David_Blumberg
asked on
Netgear switch to Cisco switch VLAN not passing traffic
Netgear S3300 switch port set to trunk vlan 1 for admin and 300 for some cameras. Tag vlan 300 as T and 1 as U. Cisco SG220 switch connection set to trunk with pvid as 1 with vlan 300 tag. Specific ports on Cisco switch set to tag 300 with pvid as 1 (tried pvid) 300, but we are unable to see the cameras on systems (nvr) connected to vlan 300 on access port on Netgear. Any thoughts or suggestions?
SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.
SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.
SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.
ASKER
Ian are you sure the S2200 will do that? That seems to be intervlan routing and pretty sure the GS752TXP does not have that capability.
ASKER CERTIFIED SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.
ASKER
We ended up getting rid of the Cisco switch and installing a netgear and it worked fine. The port connected to the Cisco switch on the netgear backbone was tagged to explicitly try and pass vlan 300 per instructions as mentioned above to no effect. Thank you for trying.
ASKER
Returned Cisco switch possibly it was defective.
ASKER