nh6we
asked on
AP appears to join controller but not operating correctly
I have a Cisco 3702 which appears to join and register with my controller (shows up in the GUI) but continues to show a flashing red/green join error. The access point is visible on the controller but doesn't show an IP address or controller under high availability even though one was set on the AP via the console port at the beginning. If I go to change this, sometimes it takes but after a few min, it reverts back to no ip and no controller.
Any ideas? A log file is attached
The AP is 158.183.100.8 and mac is cc16.7eb9.a128
Thanks
session2.log
Any ideas? A log file is attached
The AP is 158.183.100.8 and mac is cc16.7eb9.a128
Thanks
session2.log
ASKER CERTIFIED SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.
ASKER