FEC Point of Sale terminal Customer display unit

I am using an FEC POS touch screen terminal, OS- Win XP.  There is a customer display unit, (CDU), (Page 2 in manual attached), as part of the terminal which lights up and shows Welcome POS System, (pic attached).  I need to be able to change it.  It appears as soon as the terminal is powered on, so I assumed it is in the BIOS.  
I've looked everywhere in the BIOS, but can't seem to find any link to the CDU
Been in touch with FEC who say they don't think it can be changed.
Surely if it is in the BIOS then it should be able to be changed.
I initially thought it may be attached to one of the com ports.
IMG_2128.JPG
MP-3275_manual_0.2.pdf
sco505Asked:
Who is Participating?
 
Scott SilvaConnect With a Mentor Network AdministratorCommented:
Don't void your warranty over it...

It should be programmable somehow since I have seen some terminals that display non generic greetings...

But if the manufacturer doesn't know, it might be hard...

Did you search the entire drive for a config file with that wording?
0
 
Scott SilvaNetwork AdministratorCommented:
It could be in the control circuit for that particular display and may be hard coded into it... You would almost have to open the unit and find out what vendor makes that small display port. I bet it is made by an outside supplier and they would know if it can be changed or not...
0
 
sco505Author Commented:
I'll give it a go.  Let you know how I get on
0
 
sco505Author Commented:
Tried to find any clue on display re manufacturer. No luck.

Checked every config file I could find, but was advised that as it lit up immediately power was on it must be hard coded, so given.

Thanks for your help
0
Question has a verified solution.

Are you are experiencing a similar issue? Get a personalized answer when you ask a related question.

Have a better answer? Share it in a comment.

All Courses

From novice to tech pro — start learning today.