Sign on as admin to change IP address of Oce Plot Wave 360 printer

I have remotely connected to an Oce Plot Wave 360 printer using a web browser and it's IP address and need to examine and change the TCP IP address assigned to this printer and its scanning properties.

The problem is that I don't see anywhere where I can logon as an administrator to make these changes.

Where do I go while logged onto the printer through a web browser using its IP address to logon as administrator to make these changes?

Or do I need to use a different IP address such as the IP address/admin?
KnowledgeableNetwork EngineerAsked:
Who is Participating?
 
Eric CConnect With a Mentor IT Director / Project ManagerCommented:
0
 
Eric CConnect With a Mentor IT Director / Project ManagerCommented:
As a security measure, you may need to set MAC address filter.

In Express WebTools:
- Configuration
- Connectivity tab
- Identification
- Click 'Edit'
- Log in as the system admin
- Define the hostname (if not already done)
- Click OK
- When prompted to restart, click 'Restart Later'
- Click OK
- Go to 'Network Adapter' section
- Click 'Edit'
- Log in as the system admin

Here you can configure TCP/IP

Click 'OK' then restart.
0
 
NiabingiCommented:
can you send a screen shot?
0
Evaluating UTMs? Here's what you need to know!

Evaluating a UTM appliance and vendor can prove to be an overwhelming exercise.  How can you make sure that you're getting the security that your organization needs without breaking the bank? Check out our UTM Buyer's Guide for more information on what you should be looking for!

 
KnowledgeableNetwork EngineerAuthor Commented:
I am actually located in a different state than where this Oce printer is.

Is there any way of being able to logon to the printer using a web browser from a computer on the same LAN to make these changes or do i first need someone to go to the printer's console to make some of these changes such as adding a Mac address of a computer that will be authorized to make these changes?
0
 
NiabingiCommented:
looks like Eric C pointed you to the correct steps, are the edit options grayed out.
you should be able to click edit and make the changes you need
0
 
Eric CIT Director / Project ManagerCommented:
If you are not able to edit the TCP/IP configuration via the Web browser then it sounds like the MAC filter was not configured for you to do remote admin. Having someone on-site to do it via the control panel on the machine is your only option in this case.
0
All Courses

From novice to tech pro — start learning today.