ggRM7865
asked on
Outbound call in G.722
Hello,
we have a Cisco Unified CM ver 8.6.2 managing our VoIP calls. As test I was asked to configure one (and only one) DN line to use the code g722. Checking around the CUCM configuration I see that the g722 is indeed enabled (see attachment) but how can I configure only a specific DN to use this code without effecting the rest of the lines in production? And is there any configuration change also for the Cisco IP Phone to use this codec?
thank you
codec.jpg
we have a Cisco Unified CM ver 8.6.2 managing our VoIP calls. As test I was asked to configure one (and only one) DN line to use the code g722. Checking around the CUCM configuration I see that the g722 is indeed enabled (see attachment) but how can I configure only a specific DN to use this code without effecting the rest of the lines in production? And is there any configuration change also for the Cisco IP Phone to use this codec?
thank you
codec.jpg
Not sure it can be done at the DN level, but at a site level you can
This question needs an answer!
Become an EE member today
7 DAY FREE TRIALMembers can start a 7-Day Free trial then enjoy unlimited access to the platform.
View membership options
or
Learn why we charge membership fees
We get it - no one likes a content blocker. Take one extra minute and find out why we block content.