Solved

Applying linux patch grid

Posted on 2016-08-05
2
36 Views
Last Modified: 2016-08-27
How  we  apply patches on linux servers in grid infra structure?
0
Comment
Question by:taaz
  • 2
2 Comments
 
LVL 62

Accepted Solution

by:
gheist earned 500 total points (awarded by participants)
ID: 41747814
one by one manually or buy expensive grid/cloud/whatever enterprise control
0
 
LVL 62

Expert Comment

by:gheist
ID: 41772812
gheist says free cloud/grid control is read-only.
0

Featured Post

VMware Disaster Recovery and Data Protection

In this expert guide, you’ll learn about the components of a Modern Data Center. You will use cases for the value-added capabilities of Veeam®, including combining backup and replication for VMware disaster recovery and using replication for data center migration.

Question has a verified solution.

If you are experiencing a similar issue, please ask a related question

Suggested Solutions

Using libpcap/Jpcap to capture and send packets on Solaris version (10/11) Library used: 1.      Libpcap (http://www.tcpdump.org) Version 1.2 2.      Jpcap(http://netresearch.ics.uci.edu/kfujii/Jpcap/doc/index.html) Version 0.6 Prerequisite: 1.      GCC …
Introduction We as admins face situation where we need to redirect websites to another. This may be required as a part of an upgrade keeping the old URL but website should be served from new URL. This document would brief you on different ways ca…
Learn how to find files with the shell using the find and locate commands. Use locate to find a needle in a haystack.: With locate, check if the file still exists.: Use find to get the actual location of the file.:
In a previous video, we went over how to export a DynamoDB table into Amazon S3.  In this video, we show how to load the export from S3 into a DynamoDB table.

828 members asked questions and received personalized solutions in the past 7 days.

Join the community of 500,000 technology professionals and ask your questions.

Join & Ask a Question