2920 split Stack and OOBM

have two HP 2920s version WB16.02.0008  

Setup in stack using stacking module and setup OOBM connected via third switch.
Member 1 is the commander, Member 2 standby


OOBM IP 10.255.252.80
OOBM Member 1 10.255.252.81
OOBM Member 2 10.255.252.82

During a split stack situation with OOBM configured should get a screen similar to this
HP Stack 2920# sh oobm ip
 
  IPv4 Status    : Enabled
  IPv4 Default Gateway : 10.255.252.1
 
        |                                     Address  Interface
Member | IP Config IP Address/Prefix Length  Status   Status
------ + --------- ------------------------- -------- ---------
Global | manual    10.255.252.80/24          Active   Up
1      | manual    10.255.252.80/24          Active   Up
2      | manual    10.255.252.82/24          Active   Up

I am actually getting the following screen


HP Stack 2920# sh oobm ip
 
  IPv4 Status    : Enabled
  IPv4 Default Gateway : 10.255.252.1
 
        |                                     Address  Interface
Member | IP Config IP Address/Prefix Length  Status   Status
------ + --------- ------------------------- -------- ---------
Global | manual    10.255.252.80/24          Active   Up
1      | manual    10.255.252.80/24          Active   Up
2      | manual    10.255.252.82/24          Missing   Down


Was following the following HP article: http://h22208.www2.hpe.com/eginfolib/networking/docs/switches/WB/15-18/5998-8156_wb_2926_atmg/content/ch06s04.html