Solved

Routing help VPN -- CORP ASA -- AWS

Posted on 2016-08-20
1
45 Views
Last Modified: 2016-08-21
My AnyConnect VPN (172.16/16) can access my CORP Cisco ASA network (10/8) no problems at all through split tunnel.  Recently I created a site-to-site VPN from CORP to AWS (172.20/16).  Can't figure out now how to allow VPN clients to access my AWS network.  Is there some route that needs to be done on the ASA site?
0
Comment
Question by:myfootsmells
1 Comment
 
LVL 57

Accepted Solution

by:
Pete Long earned 500 total points
ID: 41764328
You need to hairpin the VPNS together :)

See the following article

Cisco Firewall VPN “Hair Pinning” Note: Cisco refer to this as a “Spoke to Spoke VPN”

Pete
0

Featured Post

PRTG Network Monitor: Intuitive Network Monitoring

Network Monitoring is essential to ensure that computer systems and network devices are running. Use PRTG to monitor LANs, servers, websites, applications and devices, bandwidth, virtual environments, remote systems, IoT, and many more. PRTG is easy to set up & use.

Question has a verified solution.

If you are experiencing a similar issue, please ask a related question

Suggested Solutions

Title # Comments Views Activity
OSPF metric and destination 2 36
Allowing Multicast in the firewall 2 42
Confused about VPN connection and private IP addresses..?? 5 41
RDP ISR4321 Cisco Router 7 23
This article will cover setting up redundant ISPs for outbound connectivity on an ASA 5510 (although the same should work on the 5520s and up as well).  It’s important to note that this covers outbound connectivity only.  The ASA does not have built…
From Cisco ASA version 8.3, the Network Address Translation (NAT) configuration has been completely redesigned and it may be helpful to have the syntax configuration for both at a glance. You may as well want to read official Cisco published AS…
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…

932 members asked questions and received personalized solutions in the past 7 days.

Join the community of 500,000 technology professionals and ask your questions.

Join & Ask a Question

Need Help in Real-Time?

Connect with top rated Experts

12 Experts available now in Live!

Get 1:1 Help Now