Static NAT on Cisco Router

I having an issue routing traffic out of our cisco router out to the global internet. I have nat setup, I can ping to the outside interface from the inside network but traffic doesn't exit the router. Clean router with no access list, we can ping 8.8.8.5 from outside but unable to access webpage. Any clues ?

Cisco config

Router>
Router>en
Router#conf t
Enter configuration commands, one per line.  End with CNTL/Z.
Router(config)#do show run
Building configuration...
!
interface GigabitEthernet0/0
 ip address 8.8.8.4 255.255.255.248
 ip nat outside
 ip virtual-reassembly in
 duplex auto
 speed auto
!
interface GigabitEthernet0/1
 ip address 10.224.0.151 255.255.0.0
 ip nat inside
 ip virtual-reassembly in
 duplex auto
 speed auto
!
ip forward-protocol nd
!
no ip http server
no ip http secure-server
!
ip nat inside source static tcp 10.224.0.152 80 8.8.8.5 80 extendable
ip nat inside source static tcp 10.224.0.152 443 8.8.8.5 443 extendable
!
Iyad AlaqrabawiAsked:
Who is Participating?
 
SIM50Connect With a Mentor Commented:
define your internal network:
access-list 100 permit ip 10.224.0.0 0.0.255.255 any

bind it to outside interface:
ip nat inside source list 100 interface  GigabitEthernet0/0 overload

verify nat:
sh ip nat translations
0
 
Craig BeckConnect With a Mentor Commented:
In addition to what SIM50 said, and assuming you didn't cut it out of the snippet you provided, you don't appear to have a default route pointing out of your Gig0/0 interface.  You won't get anywhere without that.

ip route 0.0.0.0 0.0.0.0 8.8.8.5

Open in new window

0
 
Craig BeckCommented:
Best answer chosen
0
Question has a verified solution.

Are you are experiencing a similar issue? Get a personalized answer when you ask a related question.

Have a better answer? Share it in a comment.

All Courses

From novice to tech pro — start learning today.