Solved

change vmware workstation  nat configuration

Posted on 2016-09-08
4
32 Views
Last Modified: 2016-12-10
i'm using vmware workstation  10 on a windows 10 host i want to build a private nat  network  with the following adresses :
subnet ip : 172.20.10.0 subnet mask : 255.255.255.0 gateway ip : 172.20.10.1 DHCP start ip address : 172.20.10.10 End ip address : 172.20.10.254.
but when i make changes in virtual editor the VMs  can't ping the host . ( one VM network config is ip address : 172.20.10.10 mask 255.255.255.0 dns server 172.20.10.1 wins server : 172.20.10.1)
0
Comment
Question by:Member_2_7968106
4 Comments
 
LVL 119

Accepted Solution

by:
Andrew Hancock (VMware vExpert / EE MVE^2) earned 250 total points (awarded by participants)
ID: 41790892
You will need to make sure you change the network using the Network Editor, and put in all your IP Addresses.

also change the IP Address of the virtual network adaptors.
1
 
LVL 93

Assisted Solution

by:John Hurst
John Hurst earned 250 total points (awarded by participants)
ID: 41791126
I agree with the above. I have also found it is helpful to Reset the Virtual Network Editor to defaults (You must start the Network Editor with Run as Administrator). Then set your new NAT IP address range.  Make sure you are setting VMNet8
0
 

Author Comment

by:Member_2_7968106
ID: 41920381
Thanks Andrew the problème was. About the virtual network adapter. I neded to change the settings
0

Featured Post

Simplifying Server Workload Migrations

This use case outlines the migration challenges that organizations face and how the Acronis AnyData Engine supports physical-to-physical (P2P), physical-to-virtual (P2V), virtual to physical (V2P), and cross-virtual (V2V) migration scenarios to address these challenges.

Question has a verified solution.

If you are experiencing a similar issue, please ask a related question

When we have a dead host and we lose all connections to the ESXi, and we need to find a way to move all VMs from that dead ESXi host.
HOW TO: Connect to the VMware vSphere Hypervisor 6.5 (ESXi 6.5) using the vSphere (HTML5 Web) Host Client 6.5, and perform a simple configuration task of adding a new VMFS 6 datastore.
Teach the user how to install ESXi 5.5 and configure the management network System Requirements: ESXi Installation:  Management Network Configuration: Management Network Testing:
This video shows you how easy it is to boot from ISO images for virtual machines with the ISO images stored on a local datastore on the ESXi host.

785 members asked questions and received personalized solutions in the past 7 days.

Join the community of 500,000 technology professionals and ask your questions.

Join & Ask a Question