Solved

unable to configure Virtual IP in suse 11

Posted on 2016-09-12
2
20 Views
Last Modified: 2016-09-20
Hi All,

I have configured VIP so many times in redhat but this in suse and its not working please advice

/etc/sysconfig/network # ll
total 104
-rw-r--r-- 1 root root 14194 Apr  6 09:24 config
-rw-r--r-- 1 root root 10393 Apr  6 09:00 dhcp
-rw-r--r-- 1 root root   194 Sep 13 08:13 ifcfg-eth0
-rw-r--r-- 1 root root    69 Sep 13 08:43 ifcfg-eth0:0


/etc/sysconfig/network # cat ifcfg-eth0:0
DEVICE='eth0:0'
IPADDR='10.1.235.106/24'
NETWORK=''
STARTMODE='auto'



please help
0
Comment
Question by:The Rock
2 Comments
 
LVL 18

Accepted Solution

by:
ZENandEmailguy earned 500 total points
ID: 41796888
Using the YaST or YaST2 utility (the 2 is graphical...both are launched from a terminal in all lowercase).

Choose Network Devices
Choose Network Card
Once into the list of network cards, highlight the one you want if there are more than one and choose Edit
In the large box below the static IP address, click Add
Enter a short name of your choosing, the IP, subnet and then click OK
Click OK to accept the changes and then Next to finish the setup.  It will auto-run the suseconfig process and write info to the files plus restart networking.  You should be good to go from there.

If not, post back and perhaps I can help you via a remote session.

Scott
0
 

Author Closing Comment

by:The Rock
ID: 41807940
Thanks it works .
0

Featured Post

How your wiki can always stay up-to-date

Quip doubles as a “living” wiki and a project management tool that evolves with your organization. As you finish projects in Quip, the work remains, easily accessible to all team members, new and old.
- Increase transparency
- Onboard new hires faster
- Access from mobile/offline

Join & Write a Comment

If you have a server on collocation with the super-fast CPU, that doesn't mean that you get it running at full power. Here is a preamble. When doing inventory of Linux servers, that I'm administering, I've found that some of them are running on l…
Note: for this to work properly you need to use a Cross-Over network cable. 1. Connect both servers S1 and S2 on the second network slots respectively. Note that you can use the 1st slots but usually these would be occupied by the Service Provide…
Learn how to find files with the shell using the find and locate commands. Use locate to find a needle in a haystack.: With locate, check if the file still exists.: Use find to get the actual location of the file.:
Connecting to an Amazon Linux EC2 Instance from Windows Using PuTTY.

758 members asked questions and received personalized solutions in the past 7 days.

Join the community of 500,000 technology professionals and ask your questions.

Join & Ask a Question

Need Help in Real-Time?

Connect with top rated Experts

20 Experts available now in Live!

Get 1:1 Help Now