Link to home
Start Free TrialLog in
Avatar of MoonLive
MoonLive

asked on

HP Procurve Fault-finder

I have HP Procurve 3500yl POE swithes and one of the switch showing following:
fault-finder bad-driver sensitivity high
fault-finder bad-transceiver sensitivity high
fault-finder bad-cable sensitivity high
fault-finder too-long-cable sensitivity high
fault-finder over-bandwidth sensitivity high
fault-finder broadcast-storm sensitivity high
fault-finder loss-of-link sensitivity high
fault-finder duplex-mismatch-hdx sensitivity high
fault-finder duplex-mismatch-fdx sensitivity high
power-over-ethernet pre-std-detect

Are those errors or is it on configuration? Not sure what it is. Any suggestion helps..Thanks
ASKER CERTIFIED SOLUTION
Avatar of Kimputer
Kimputer

Link to home
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.
Start Free Trial
Avatar of MoonLive
MoonLive

ASKER

Kimputer,  so it is setting to report, but i don't see setup where it send it too.
snmp-server host 169.254.59.232 community "public" is on config file so i guess it is not going to report anywhere. Thanks
It might not always report if there's no function for that. In that case, it's only logged in its own log files.
Thanks for the prompt replay and good answers!