• Status: Solved
  • Priority: Medium
  • Security: Public
  • Views: 139
  • Last Modified:

Anyone Remember Netware 3.12?

I have a customer that pulled and old server out of the basement and wants to try and bring it back. It did not boot so I found a similar one (PATA Hard Drive) and the drive seemed to boot. The drive was on the secondary IDE channel and I remembered enough to load ISADISK at 170 INT F wasn't it? It loaded but still can't mount SYS.

FDISK does reflect a non-DOS partition. What else can I try?
1 Solution
On the dos partition ,there should be a file called startup.ncf,it's just a batch file that can be opened with notepad or any ascii editor,post it .
Most modern patched 3.12 used ideata ham drivers .
Isadisk was pretty much abandoned.
LockDown32OwnerAuthor Commented:
The server boots. I can edit both the autoexec.ncf and startup.ncf after "load install" and modify them to my hearts content. The ideata.ham seemed to work. Good memory :)
Question has a verified solution.

Are you are experiencing a similar issue? Get a personalized answer when you ask a related question.

Have a better answer? Share it in a comment.

Join & Write a Comment

Featured Post

Free Tool: Site Down Detector

Helpful to verify reports of your own downtime, or to double check a downed website you are trying to access.

One of a set of tools we are providing to everyone as a way of saying thank you for being a part of the community.

Tackle projects and never again get stuck behind a technical roadblock.
Join Now