Solved

Fail over server for Rapid Recovery

Posted on 2016-10-07
2
25 Views
Last Modified: 2016-11-22
Hello All,

Im trying to find some information on how to setup the raid configuration of the servers Operating system for the rapid recovery fail over server im going to be using windows server 2012 R2 with four western digital hard drives all 300 gigs. Im just trying to figure out what raid configuration to use for this server   please help
0
Comment
Question by:George Martinez
2 Comments
 
LVL 33

Accepted Solution

by:
paulmacd earned 500 total points
ID: 41833754
The answer to this will depend on how the RAID array is to be used, and how much storage space you need.  RAID 10 will get you speed and fault tolerance, but you'll "lose" half your disk capacity.  RAID 5 will get you fault tolerance (and only "cost" you 300GB), but disk access will be a little slower.

What are your priorities?
0
 

Author Closing Comment

by:George Martinez
ID: 41897741
question was answered
0

Featured Post

IT, Stop Being Called Into Every Meeting

Highfive is so simple that setting up every meeting room takes just minutes and every employee will be able to start or join a call from any room with ease. Never be called into a meeting just to get it started again. This is how video conferencing should work!

Join & Write a Comment

Suggested Solutions

In this CloudClass Webinar, Quest (http://www.questsys.com/) CTO Mike Dillon gives an overview of the steps involved in building a dynamic disaster recovery plan. Through case studies and an examination of software/hardware tools for monitoring an…
A Bare Metal Image backup allows for the restore of an entire system to a similar or dissimilar hardware. They are highly useful for migrations and disaster recovery. Bare Metal Image backups support Full and Incremental backups. Differential backup…
In this Micro Tutorial viewers will learn how to use Boot Corrector from Paragon Rescue Kit Free to identify and fix the boot problems of Windows 7/8/2012R2 etc. As an example is used Windows 2012R2 which lost its active partition flag (often happen…
In this Micro Tutorial viewers will learn how to restore their server from Bare Metal Backup image created with Windows Server Backup feature. As an example Windows 2012R2 is used.

744 members asked questions and received personalized solutions in the past 7 days.

Join the community of 500,000 technology professionals and ask your questions.

Join & Ask a Question

Need Help in Real-Time?

Connect with top rated Experts

12 Experts available now in Live!

Get 1:1 Help Now