Still celebrating National IT Professionals Day with 3 months of free Premium Membership. Use Code ITDAY17

x
?
Solved

NIC card with 2 RJ45 ports doesnt detect second port

Posted on 2016-10-11
1
Medium Priority
?
57 Views
Last Modified: 2016-10-11
Hello all,

I got a 2 port pci express gigabit ethernet network card of Startech ( ST1000SPEXD3 ) and I put it in a PC. I installed all drivers and now I am testing the card. I put network cable in the first port, it works. I put the cable in the second port, nothing happens..

Is there any config I need to do for using the second port of that card or?
0
Comment
Question by:Triforce2000
[X]
Welcome to Experts Exchange

Add your voice to the tech community where 5M+ people just like you are talking about what matters.

  • Help others & share knowledge
  • Earn cash & points
  • Learn & ask questions
1 Comment
 
LVL 10

Accepted Solution

by:
Muhammad Mulla earned 2000 total points
ID: 41838147
You shouldn't need to do any config for a second port.

It may be a faulty card.
0

Featured Post

Concerto Cloud for Software Providers & ISVs

Can Concerto Cloud Services help you focus on evolving your application offerings, while delivering the best cloud experience to your customers? From DevOps to revenue models and customer support, the answer is yes!

Learn how Concerto can help you.

Question has a verified solution.

If you are experiencing a similar issue, please ask a related question

If you’re involved with your company’s wide area network (WAN), you’ve probably heard about SD-WANs. They’re the “boy wonder” of networking, ostensibly allowing companies to replace expensive MPLS lines with low-cost Internet access. But, are they …
WARNING:   If you follow the instructions here, you will wipe out your VTP and VLAN configurations.  Make sure you have backed up your switch!!! I recently had some issues with a few low-end Cisco routers (RV325) and I opened a case with Cisco TA…
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…
Michael from AdRem Software explains how to view the most utilized and worst performing nodes in your network, by accessing the Top Charts view in NetCrunch network monitor (https://www.adremsoft.com/). Top Charts is a view in which you can set seve…
Suggested Courses

715 members asked questions and received personalized solutions in the past 7 days.

Join the community of 500,000 technology professionals and ask your questions.

Join & Ask a Question