Solved

Domain and Split DNS Names for Cisco VPN Client 5.0.07

Posted on 2016-10-17
1
22 Views
Last Modified: 2016-10-25
I have a user who cannot connect to the Internet nor to our corporate drives after apparently authenticating through VPN.  I captured a log and found the "Domain" and "Split DNS Names" values are not populated.  Is there a way to make the client populate these values?  I want to see if changing these values would help.  

Also, could the "0.0.0.0" be blocking further routing?  

28     13:23:11.337  10/03/16  Sev=Info/4      CM/0x63100034
The Virtual Adapter was enabled:
      IP=192.168.13x.xxx/255.255.255.0
      DNS=192.168.130.xxx,192.168.130.xxx
      WINS=192.168.130.xxx,0.0.0.0
      Domain=
      Split DNS Names=
0
Comment
Question by:tmaususer
1 Comment
 
LVL 15

Accepted Solution

by:
max_the_king earned 500 total points
ID: 41847823
Hi,
chances are that you need to configure splittunnel on the VPN concentrator.

If it is a Cisco ASA device, here is the config:

access-list splittunnel extended permit ip 192.168.130.0 255.255.255.0 <subnet given to vpn clients>  255.255.255.0

group-policy yourgroup internal
group-policy yourgroup attributes
 split-tunnel-policy tunnelspecified
 split-tunnel-network-list value splittunnel

for example, if the ip pool assigned to vpn clients is 10.10.10.0 255.255.255.0, the above access-list would be

access-list splittunnel extended permit ip 192.168.130.0 255.255.255.0 10.10.10.0  255.255.255.0

hope this helps
max
0

Featured Post

IT, Stop Being Called Into Every Meeting

Highfive is so simple that setting up every meeting room takes just minutes and every employee will be able to start or join a call from any room with ease. Never be called into a meeting just to get it started again. This is how video conferencing should work!

Join & Write a Comment

Secure VPN Connection terminated locally by the Client.  Reason 442: Failed to enable Virtual Adapter. If you receive this error on Windows 8 or Windows 8.1 while trying to connect with the Cisco VPN Client then the solution is a simple registry f…
This is an article about my experiences with remote access to my clients (so that I may serve them) and eventually to my home office system via Radmin Remote Control. I have been using remote access for over 10 years and have been improving my metho…
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…

743 members asked questions and received personalized solutions in the past 7 days.

Join the community of 500,000 technology professionals and ask your questions.

Join & Ask a Question

Need Help in Real-Time?

Connect with top rated Experts

12 Experts available now in Live!

Get 1:1 Help Now