Is my AD schema correct ?

Hi Experts,

I am in the process to upgrade from EXCH2007 to 2013.
About the Schema update , the domain and forest update I am not sure.
Can I do the POWERSHELL commands again  to check it ?
Eprs_AdminSystem ArchitectAsked:
Who is Participating?
 
IvanSystem EngineerCommented:
Hi,

I haven't run it more then once, so not sure. Don't think it will do any problem, since I do know that sometime, when you get into problem with arbitration mailboxes, it is required to run those commands again.
0
 
IvanSystem EngineerCommented:
Hi,

from PowerShell, with Run As Admin type:

[PS] C:\> "Exchange Schema Version = " + ([ADSI]("LDAP://CN=ms-Exch-Schema-Version-Pt," + ([ADSI]"LDAP://RootDSE").schemaNamingContext)).rangeUpper

Then take a look at this site, to see on what version you are: https://eightwone.com/references/schema-versions/

Regards,
Ivan.
0
 
Eprs_AdminSystem ArchitectAuthor Commented:
Ok I have checke dthis in ADSIEDIT.
The range is ok.

Can I rerun these commands ?

\setup /p
\setup /ps

and so on.....

Or do I get problems when I do it ?
0
 
IvanSystem EngineerCommented:
Hi,

if you have already run those commands, then there is no reason to run them again.
You can just run installation.

Regards,
0
 
Eprs_AdminSystem ArchitectAuthor Commented:
is it possible to run the commands again ?
Just to verify it ?
0
Question has a verified solution.

Are you are experiencing a similar issue? Get a personalized answer when you ask a related question.

Have a better answer? Share it in a comment.

All Courses

From novice to tech pro — start learning today.