Solved

Dual WAN setup

Posted on 2016-10-28
3
15 Views
Last Modified: 2016-11-09
We need to replace a TP-Link TL-R480T+ router with a Cisco RV320. We had our dual WAN setup working fine on the TP Link.

We put  in the exact same IP routes to the WAN connections on the RV320, but the end result is that the internet is very slow. There is also an internet application that needs to be accessed from WAN2, and that one is also very slow.

What could be the reason for this?
0
Comment
Question by:ICTSYSTEMS
  • 2
3 Comments
 
LVL 13

Expert Comment

by:SIM50
Comment Utility
I would first check if there are errors on the interfaces and statically configure link speed and duplex instead of auto.
0
 
LVL 1

Accepted Solution

by:
ICTSYSTEMS earned 0 total points
Comment Utility
It appears you need to disable service detection on the WAN interfaces. Now everything works fine.

Although I thought it was...

After 2 days the Exchange 2007 server decided to delay the email. I'm getting error 451 4.4.0 primary target ip address responded with 421 4.2.1 unable to connect.
0
 
LVL 1

Author Closing Comment

by:ICTSYSTEMS
Comment Utility
Everything works now. Disabled service detection and the Exchange issue was just a DNS server missing at one of the WAN connections.
0

Featured Post

How your wiki can always stay up-to-date

Quip doubles as a “living” wiki and a project management tool that evolves with your organization. As you finish projects in Quip, the work remains, easily accessible to all team members, new and old.
- Increase transparency
- Onboard new hires faster
- Access from mobile/offline

Join & Write a Comment

Have you experienced traffic destined through a Cisco ASA firewall disappears and you do not know if the traffic stops in the firewall or somewhere else? The solution is the capture feature. This feature was released in 6.2(1) and works in all firew…
There are two basic ways to configure a static route for Cisco IOS devices. I've written this article to highlight a case study comparing the configuration of a static route using the next-hop IP and the configuration of a static route using an outg…
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…

772 members asked questions and received personalized solutions in the past 7 days.

Join the community of 500,000 technology professionals and ask your questions.

Join & Ask a Question

Need Help in Real-Time?

Connect with top rated Experts

12 Experts available now in Live!

Get 1:1 Help Now