Solved

EIGRP Summary

Posted on 2016-11-07
2
51 Views
Last Modified: 2016-11-11
I have been reading the article on this link:
https://ccieblog.co.uk/eigrp/eigrp-query-scoping-using-summarisation
when the link between R8 and R9 fails, why do the queries "who has the route to 10.1.0.0" has to go all the way to Router R6 in order to have a Reply.
Why not just R2 or R1 can reply to the query or  the farthest it can go is up to R3 and they can reply with "I do not have the route"

Thank you
eg
0
Comment
Question by:jskfan
  • 2
2 Comments
 

Accepted Solution

by:
jskfan earned 0 total points
ID: 41884391
0
 

Author Closing Comment

by:jskfan
ID: 41884392
Good link
0

Featured Post

PRTG Network Monitor: Intuitive Network Monitoring

Network Monitoring is essential to ensure that computer systems and network devices are running. Use PRTG to monitor LANs, servers, websites, applications and devices, bandwidth, virtual environments, remote systems, IoT, and many more. PRTG is easy to set up & use.

Question has a verified solution.

If you are experiencing a similar issue, please ask a related question

Suggested Solutions

Title # Comments Views Activity
Port 808 is being blocked 9 101
Managed vs unmanaged switches 8 53
What problem can Native VLAN mismatch causes 4 37
Unmanaged Switches for Optimized Network Speeds 7 39
I see many questions here on Experts Exchange regarding switch port configurations and trunks. This article is meant for beginners in the subject to help to get basic knowledge about Virtual Local Area Network (VLAN (http://en.wikipedia.org/wiki/Vir…
Hello , This is a short article on how would you go about enabling traceoptions on a Juniper router . Traceoptions are similar to Cisco debug commands but these traceoptions are implemented in Juniper networks router . The following demonstr…
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…

777 members asked questions and received personalized solutions in the past 7 days.

Join the community of 500,000 technology professionals and ask your questions.

Join & Ask a Question