I am trying to set the port speed of a switch to 100 mb full duplex but the port does not recognize the commands below is the configuration on the port currently
ip address 10.251.250.36 255.255.255.248
This port needs to match the other side that it connects to in order to communicate across the PTP wireless link. Port speeds and duplexing mode need to match. Does anyone know how I can set these 2 commands? I tried "duplex full" and "speed 100" but neither one works......and yes I am in the interface in Configuration T mode. For speed ? I get the options nonegotiate Do not negotiate speed.
Quip doubles as a “living” wiki and a project management tool that evolves with your organization. As you finish projects in Quip, the work remains, easily accessible to all team members, new and old.
- Increase transparency
- Onboard new hires faster
- Access from mobile/offline
How to configure Site to Site VPN on a Cisco ASA. (version: 1.1 - updated August 6, 2009)
2. [The situation]
3. [Getting started]
4. [Interesting traffic]
Have you experienced traffic destined through a Cisco ASA firewall disappears and you do not know if the traffic stops in the firewall or somewhere else? The solution is the capture feature. This feature was released in 6.2(1) and works in all firew…
Excel styles will make formatting consistent and let you apply and change formatting faster. In this tutorial, you'll learn how to use Excel's built-in styles, how to modify styles, and how to create your own. You'll also learn how to use your custo…
In this tutorial you'll learn about bandwidth monitoring with flows and packet sniffing with our network monitoring solution PRTG Network Monitor (https://www.paessler.com/prtg).
If you're interested in additional methods for monitoring bandwidt…