mystikal1000
asked on
Only allow one site in Internet Explorer on XenApp.
Does anyone know a good way of only allowing one URL accessible in IE 11 on XenApp. I know there are ways to block hotkeys, menus, I know how to do that.
But I want to block all access, except for the particular site. I was thinking a proxy file, .pac? Anyone have any good suggestions.
But I want to block all access, except for the particular site. I was thinking a proxy file, .pac? Anyone have any good suggestions.
ASKER
I rather do it from a server level... Don't want to touch fw at all. Anyone know how to setup a proxy PAC file?
ASKER CERTIFIED SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.
ASKER
Whoops - Revised the last comment.
Prevent Changes to Proxy IE
HKCU\Software\Policies\Mic rosoft\Int ernet Explorer\Control Panel
Value Name=Proxy
Reg_DWord = 1
Prevent Changes to Proxy IE
HKCU\Software\Policies\Mic
Value Name=Proxy
Reg_DWord = 1
ASKER
Apologies for the delay!
I guess that if you have some servers or stations that did need wider access could a rule be created that would limit requests from certain IP's to only go to the one site.
I am not certain of how to do it through Group Policies.