vmagan
asked on
what is the difference between Cisco catalyst 2960 and Cisco series SG300-52MP?
I am going to replace our Cisco catalyst 2960 48 port poe switches. I am considering going with the Cisco series SG300-52MP. I see that this model uses primarily the GUI. Am i still able to use the CLI and its full configuration just like my current switches? Are there any draw backs to converting to these 300 series switches?
please advise and thanks in advance
please advise and thanks in advance
ASKER CERTIFIED SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.
The sg300 don't stack at all. Use the sg500x if you want 10g sfp+ or the sg500 for 1g uplinks.
Good spot, Aaron! You are correct; the 300 doesn't stack. I meant to say uplink at the front rather than stack.
ASKER
So the 300 model ports are not 1gb ? I'm not going to be stacking so not worried about that.
SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.
ASKER
thanks
ASKER