Link to home
Start Free TrialLog in
Avatar of Marcos Santo
Marcos SantoFlag for Netherlands

asked on

Packet Tracer Router to Router

Hi Experts,

I have a network in Packet tracer with 2 DHCP Servers and 4 PC's. they get the DHCP is working and i can ping all devices. Except from one side to the other. I Configured RIP but this doesn't seem to work any suggestions?

User generated imageUser generated image
ASKER CERTIFIED SOLUTION
Avatar of Tycho N
Tycho N
Flag of Netherlands image

Link to home
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.
Start Free Trial
SOLUTION
Avatar of Predrag Jovic
Predrag Jovic
Flag of Poland image

Link to home
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.
Start Free Trial
Avatar of Marcos Santo

ASKER

Thank You
That is accepted solution???
:)

That suggestion don't do anything simply you don't have networks 10.0.0.0 in your topology.
No, but it did work for me, but yours could work aswell. the only thing i changed was gigabit 0/1 to a 10.0.0.0 address on both routers and now i can ping. And i added the addres range in RIP.
That was not what solution suggested.
:)
It was just adding network 10.0.0.0 to RIP list.

What you are describing sure can work (since you changes network address range that connect switches to 10.0.0.0 range), but it was not suggested solution.
Without changing interface addresses to 10.0.0.0 range suggestion can't work.
I will add your comment to my personal knowledgebase to try it out later, also i can't change the assist or solution. Thank you for the reaction!
Points are not big deal.
:)
You need to learn it properly or later you will need to correct it.
Misunderstood learning materials are hard to correct and will cause you a lot of pain later when you get into complex material. You need to understand basics, building brick house is hard if foundation is not stable.
I will try and get a network working with your information but it is not clear where what to do? Could you say it by ethernet 0/0 or 0/1. in the network i send in the network is connected with 0/0 and the router to router uses 10.0.0.1 and 10.0.0.2. how should i do this different? And the DHCP is good? Would you recommend cross over or serial connection.
The routes you suggested is that in RIP or in the static?

Thanks in advance
If all of the interfaces are configured according to drawing in original question.

All commands are global configuration commands (except of course #sh ip route).
Router 0
en
conf t
ip route 0.0.0.0 0.0.0.0 192.168.3.253

Open in new window


Router 1
en
conf t
ip route 0.0.0.0 0.0.0.0 192.168.3.254

Open in new window


192.168.3.25x - points what is the next router to reach specific network address range, in this case - default route (any address if more specific route is not found in routing table).