Leigh Kalbli
asked on
cradle point vpn to sonicwall
I have a cradle point AER 1600 WAN modem testing it for remote sites. Trying to set up VPN to a Sonicwall NSA2400. after following the procedures to configure for vpn, using a simple pre-shared key for the test, the VPN LED on the cradlepoint is active. There are however no active tunnel connections when looking in the NSA or under the logs. I am trying to set this up as a pilot for the possible deployment of mult-site branches. Has anyone deployed in this scenario. I have followed several guides on how to do this but am unable to reach main branch resources from the cradle point.
SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.
ASKER CERTIFIED SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.
SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.
ASKER
Thanks for the help. Quite a few things going on. The instructions for the tz205 were a bit outdated compared to the NSA 2400's. I had a case with Soniwall open to look into it and we resolved it. The section on the tz205 that says create a LAN obeject for the CP was wrong and it needed to be a VPN object. I can past the transcript steps for those intersted. The other thing was potentially a firmware issue but after downgrading and then reapplying fw, we got it working.
Thanks
Thanks
ASKER
Thanks for the link. i have followed that and many others in trying to set this up. I have support cases in to CP.