Eprs_Admin
asked on
EXCH2013 receive connectors problems
Hi Experts,
I have a question regarding receiver connectors in EX2013.
I have active all default receive connectors. here is one for port 25 and all IP ranges.
What happens when I set up a new receive connector, lets say for the subnet 10.5.1.0 and Port 25.
Which receive connector is used first ?
I have a question regarding receiver connectors in EX2013.
I have active all default receive connectors. here is one for port 25 and all IP ranges.
What happens when I set up a new receive connector, lets say for the subnet 10.5.1.0 and Port 25.
Which receive connector is used first ?
ASKER
ok,
what kind of permission I need from an exchange server in another domain but local connected to my network.
what kind of permission I need from an exchange server in another domain but local connected to my network.
ASKER CERTIFIED SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.
ASKER
Great answer, simple written, thanks a lot master.
WORKS
WORKS
Glad to help :)
if you create additional receive connector, and scope it to some ip address or range, then email sent from those addresses will be received via that connector. Default receive connector will be used for all other, just not for range configured on new connector (like 10.5.1.0/24).
You can set special permissions, that are not configured on default one.
Regards,
Ivan.