Randy Pitts
asked on
Connecting to CISCO 4402 WLC
Trying to connect with a CISCO 4402. I'm using a male to male serial cable and TeraTerm. I get nothing on the screen when I power up. My serial port is on Com1, I'm using the standard connection config, 9600 baud, 8 bit, no parity, 1bit stop, and no flow control. I've also tried using a USB to serial adapter....same result. Any suggestions?
ASKER CERTIFIED SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.
SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.
ASKER