Mitchell
asked on
FusionPBX Creating a load balancing system
Hi,
I have a Fusionpbx system (version 4.2.0) and at this point I've only been using it to route sip trunks and I've been looking around for a way to add more then one fusionpbx system but set it up in a way so both of the instances are always identical even if I make modifications on one it will replicate to the other.
My best guess on this was to tie them both into the same database but I'm not sure what the cons are on it. any suggestions would be greatly appreciated.
Thanks guys
I have a Fusionpbx system (version 4.2.0) and at this point I've only been using it to route sip trunks and I've been looking around for a way to add more then one fusionpbx system but set it up in a way so both of the instances are always identical even if I make modifications on one it will replicate to the other.
My best guess on this was to tie them both into the same database but I'm not sure what the cons are on it. any suggestions would be greatly appreciated.
Thanks guys
ASKER CERTIFIED SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.
ASKER