amigan_99
asked on
Juniper SRX3600 - block all traffic to two IP's
I want to block all traffic from reaching two IP addresses on the Internet. How do I accomplish this at the command line?
Thank you.
Thank you.
SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.
ASKER CERTIFIED SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.
You should have accept your post as solution - I just confirmed that it is OK. :)
You're welcome.
You're welcome.
Sorry, my bad (not enough coffee) I've just noticed that you did not declare application. Junos will warn you about those (zone or application not defined for policy).
set security policies from-zone corpcore-foo to-zone untrust-foo policy inside-to-butterfly-deny match application any
## Warning: missing mandatory statement(s): ' application'when you issue show command.
set security policies from-zone corpcore-foo to-zone untrust-foo policy inside-to-butterfly-deny match application any
ASKER