Mattia Minervini
asked on
convert Hyper-v vhd disk form IDE to SCSI
Hi, i have a virtual appliance on Hyper-v 2012, it has two disks attached on IDE connector.
My backup software doesn't work with IDE connector, so i have to change it to SCSI.
Can i do it? there's a procedure?
hyper-v_IDE.JPG
My backup software doesn't work with IDE connector, so i have to change it to SCSI.
Can i do it? there's a procedure?
hyper-v_IDE.JPG
You should just be able to go into the settings and "Add Hardware" select SCSI Controller and move the disk from the IDE controller to the SCSI controller. With that said.. I've never actually been in a situation where I had to switch it, so I'm not 100% certain..
to boot you need a type 2 VM if using SCSI
ASKER
where i can check if actual vm is type 2?
ok for add a scsi controller, but moving step is not so clear for me
ok for add a scsi controller, but moving step is not so clear for me
Your backup software doesn't support IDE, where did you get that from? Very few of the backup systems out there have any idea about the underlying hardware, they only know about the file system which isn't any different on IDE or SCSI
ASKER CERTIFIED SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.
ASKER
not necessary