dogdaypm
asked on
What is the command(s) needed to pull the full configuration from a Cisco WLC, but without all the AP/Client radio/signal data?
On other network devices such as Cisco switches or Aruba wireless controllers, a show start, show running-config, or show config will show all the commands/settings on the device in text format. On a Cisco wireless controller, the show running-config will pull large amounts of data about the AP radios/signal and all the connected wifi clients' radios/signal as well. What command on a Cisco controller will be similar to the Aruba controller's "show config", or a Cisco switch's "show start"?
ASKER CERTIFIED SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.
ASKER