jly999
asked on
Meraki SSID Setup
I'm trying to setup an SSID (vlan 30) in bridge mode, but whenever i change from NAT mode, it automatically changes back.
I'm using a Meraki MX-100 and 2x MR-18 AP's connected to Cisco switches
Vlan 30 is configured on the switches, trunk ports connect all devices & vlan 30 is allowed between AP's, MX-100 and Switches.
So setup looks like this
AP1 ---> Cisco-ASW1 --->Core-SW1--->Meraki-MX1 00--->Fire wall(Inter net)
Anyone know why I can't set the SSID to Bridge Mode?
Thanks
I'm using a Meraki MX-100 and 2x MR-18 AP's connected to Cisco switches
Vlan 30 is configured on the switches, trunk ports connect all devices & vlan 30 is allowed between AP's, MX-100 and Switches.
So setup looks like this
AP1 ---> Cisco-ASW1 --->Core-SW1--->Meraki-MX1
Anyone know why I can't set the SSID to Bridge Mode?
Thanks
This question needs an answer!
Become an EE member today
7 DAY FREE TRIALMembers can start a 7-Day Free trial then enjoy unlimited access to the platform.
View membership options
or
Learn why we charge membership fees
We get it - no one likes a content blocker. Take one extra minute and find out why we block content.
https://documentation.meraki.com/MR/Client_Addressing_and_Bridging/SSID_Modes_for_Client_IP_Assignment